|
MEAT GRINDER KNIVES & PLATES
Not only do you have to have high quality knives and plates,but due to wear you may have to add washers to the back of the grinder auger or worm. Its function is to take up the slack from wear on from the auger and the grinder head itself. If your grinder ring will not fit tight on your grinder plate you will wind up with strings coming out of your grinder plate and a lot of sinew on the grinder knife and plate.
STANDARD EDGE.
MADE IN GERMANY FROM THE FINEST DROP FORGED STEEL
PLEASE SCROLL DOWN PAGE FOR CATALOG ITEMS
SERVICE TIPS
* TIGHTEN THE END RING HAND TIGHT ONLY*
* ALWAYS USE THE SAME KNIFE AND PLATE TOGETHER*
*NEVER OPERATE THE GRINDER WITH OUT MEAT OR MINERAL OIL*
HERE IS A TROUBLE SHOOTING GUIDE THAT IS RECOMMENDED FOR THE BIG PACKERS AND GRINDING OPERATORS, AND I THINK IT CAN BE HELPFUL TO THE SMALL OPERATOR AND THE HOME MEAT PROCESSOR SINCE THE DULLING OF A KNIFE OR BLADE CAN BE A DISTASTER WHEN STARTING A PROJECT AND NOT HAVING A BACKUP KNIFE AND GRINDING PLATE
WHAT’S THE BEST WAY TO ENSURE PROPER GRINDER START UP
THE METAL TO METAL INTERFACE OF BLADE AND THE KNIFE REQUIRES LUBRICATION DURING START UP. PROPER LUBRICATION PREVENTS UNNECESSARY KNIFE AND PLATE WEAR DUE TO OVERHEATING IT IS POSSIBLE FOR A PLATE TO REACH 800 DEGREES F IF ALLOWED TO RUN WITHOUT LUBRICATION HERE ARE SOME PROCEDURES TO PROLONG KNIFE WEAR AND PLATE LIFE.
- COAT KNIVES WITH EDIBLE GREASE DURING ASSEMBLY,
- TIGHTEN GRINDER HEAD TO “SET THE KNIFE” FOR SOME GRINDERS YOU MAY WANT SLIGHTLY BACK OFF THE RETAINING RING. BE SURE NOT TO OVER TIGHTEN.
- BRING MEAT FORWARD TO THE KNIFE BY CAREFULLY STARTING AND STOPPING THE GRINDER.
We are only selling the Highest Quality German Made Grinder Knives & Plates At this time
A question we are asked an awful lot is I have an old Meat grinder or a grinder that the company is not around anymore, and I need a grinding knife or a knife and a plate.
Here is a way to find out what size grinder knife and grinder plate that fit’s your
Meat grinder.
The #5 Grinder Knife measures tip to tip 1-3/16” the sq hole is aprox. 3/8” A
The # 8 Grinder Knife measures tip to tip 2-3/16” the sq hole is aprox 7/16”
The #10/12 Grinder Knife measures tip to tip 2-7/16” the sq hole is aprox ½”
The #22 Grinder Knife measures tip to tip 2-7/8” the sq hole is aprox 17/32”
The #32 Grinder Knife measures tip to tip 3-9/16” the sq hole is aprox 9/16”
The #5 Grinder Plate measures 2-1/16” Diameter.
The #8 Grinder Plate measures 2-7/16” Diameter
The #10/12 Grinder Plate measures 2-3/4” Diameter.
The #22 Grinder Plate measures 3-1/4” Diameter
The #32 Grinder Plate measures 3-7/8” Diameter
Why are there so much approx. measurements with all of these knifes and plates
The many problems that occur when using dull knives and blades
WWW.ONESHARPSTORE.COM 1-772-770-4383
E-MAIL onesharpstore@comcast.net
|
